An incoming check does not need a full inspection lab. A short, consistent check on arrival catches most problems early, while they are still easy to correct, and it gives both buyer and supplier a clear record of what was received.
Start with count and identity. Check the quantity against the order, and check that the part name, material, and drawing revision match what was quoted. A correct part in the wrong quantity, or a part made to an old revision, is still a problem, even if the machining itself is good.
Next, check the critical dimensions first, not every dimension. Measure the outside diameter, length, and bore that the part’s function depends on, and check them against the drawing tolerances. A bushing should be checked for bore and outside diameter; a nut should be checked for thread and across-flats; a standoff should be checked for length and thread at each end. If inspection documentation was configured for the project, compare the received parts against that documentation as well.

Then check thread and fit with the mating part. Screw the nut onto its bolt, fit the bushing onto its shaft, or assemble the standoff into its assembly, and check for binding, looseness, or cross-threading. A part that measures correctly but does not mate cleanly has still failed its function, and that test is often faster than measuring every feature.

Finally, check finish and condition. Look for burrs, scratches, dents, and discoloration, and check that the surface finish suits the intended use, whether that is sealing, appearance, or conductivity. Record any issue with a photo and a measurement, and report it promptly, with the order and drawing details, so the correction can be based on evidence rather than description alone.
Incoming check in five steps
- Count and identity: quantity, part name, material, drawing revision
- Critical dimensions: outside diameter, length, bore, as relevant
- Thread and fit: mate with bolt, shaft, or assembly
- Finish and condition: burrs, scratches, dents, discoloration
- Record and report: photo, measurement, order and drawing details
Plan the check before the order, not at the door
The most useful arrival check is agreed before the parts are made. At order stage, confirm which dimensions are critical, how they will be checked, and whether inspection documentation will accompany the delivery. Also agree how a nonconformance should be reported: a photo, a measurement, the order number and the drawing revision, sent promptly, gives the supplier a basis for correction that a general description cannot. Planning the check in advance also prevents a common dispute, where the buyer expects a dimension to have been checked and the supplier checked a different set, each in good faith.

Measuring well, and what to do with a failed check
Measure in a consistent way: check the same features, in the same order, for each delivery, and use the drawing as the reference rather than a previous batch or a sample from memory. If a part fails a check, separate it from the accepted parts, record the measurement and a photo, and keep the mating part available for the fit test, so the failure can be described in terms of function as well as size. A failure on a non-critical dimension, a failure on a critical dimension, and a failure to mate are different problems, and they lead to different corrections, so the record should make clear which kind of failure it is.
From arrival check to repeat order
An arrival check is also the record for the next order. Note which dimensions were easy to check, which mating tests mattered most, and any finish or condition issue that recurred. That note, kept with the order and drawing revision, turns the next repeat order into a check against a known standard, rather than a fresh judgement each time. The common pitfalls are checking every dimension except the critical ones, checking size without checking fit, and reporting a problem without a measurement or a photo. Avoid those three, and a short arrival check will catch most problems while they are still easy to correct.
Request a quote for brass parts — https://precimora.com/products/brass-nuts/ — and include the drawing revision and inspection needs for your next order.