Post
Carbon Steel Turned Parts: Strength, Cost, and Corrosion Protection
Carbon steel is the strongest of the common turned-part materials, and the cheapest. It is the material for a part that must carry a […]
View detailsPRECIMORA / Archive
Engineering-led information for OEM buyers, procurement teams and manufacturing engineers.
Post
Carbon steel is the strongest of the common turned-part materials, and the cheapest. It is the material for a part that must carry a […]
View detailsPost
Brass is Precimora’s default material, and for good reason: it machines beautifully, it holds a tight tolerance, and it resists corrosion in most services. […]
View detailsPost
Brass is the default material for plumbing and HVAC fittings for a reason: it machines cleanly, it resists corrosion in water, it takes a […]
View detailsPost
A thin wall on a turned part is a wall that is thin enough to move while it is being machined. That is the […]
View detailsPost
An O-ring is the simplest seal in engineering: a ring of rubber that sits in a groove and is squeezed between two surfaces to […]
View detailsPost
A chamfer is the smallest feature on a turned part, and it is the one most often left off the drawing. It is a […]
View detailsPost
A press fit is a joint with no fastener, no thread, and no adhesive. Two parts are held together by interference alone: the shaft […]
View detailsPost
A turned part is round, and most of what it does happens around its axis. But many turned parts also need a feature that […]
View detailsPost
A knurled surface is the easiest feature on a turned part to ask for and one of the easiest to specify badly. It looks […]
View detailsPost
The parts have arrived. The box is open. What happens in the next thirty minutes decides whether a problem is caught while it is […]
View detailsDrawing-led production
Send your drawing and requirements for engineering review.